Base Coat Over 2K Primer. why use a sealer over primer? base coat is 1:1 base and stabilising thinners. Primer is your sealer unless you sanded thru in spots. I sanded through to bare metal in a few spots. i just finished block sanding the 2k high build primer on my truck at 120 grit. some of the cheaper 2k's and most of the old 1k primers are bad about sucking up base paint requiring more coats. the results look very impressive. the 4:1:1:1 turns it into a primer sealer, which is a lot thinner. I don't use sealer but you need to get. I always got the impression that nothing was considered to be as good as 2k base then 2k clear coat, but the paint on aaron's. That’ll be the perfect foundation for you to put your base coat clear coat on top of. I noticed it was always at the edge of the primer after lots of research i've came to the conclusion that i'm rubbing. you should go with epoxy, but if you’re going to be 240 grit, all of your paint, then i would put two medium to heavy coats of 2k filler primer on it and block it down with 400 grit sandpaper.
base coat is 1:1 base and stabilising thinners. That’ll be the perfect foundation for you to put your base coat clear coat on top of. I noticed it was always at the edge of the primer after lots of research i've came to the conclusion that i'm rubbing. I always got the impression that nothing was considered to be as good as 2k base then 2k clear coat, but the paint on aaron's. some of the cheaper 2k's and most of the old 1k primers are bad about sucking up base paint requiring more coats. I don't use sealer but you need to get. you should go with epoxy, but if you’re going to be 240 grit, all of your paint, then i would put two medium to heavy coats of 2k filler primer on it and block it down with 400 grit sandpaper. the results look very impressive. i just finished block sanding the 2k high build primer on my truck at 120 grit. Primer is your sealer unless you sanded thru in spots.
Clear coat over 2k paint
Base Coat Over 2K Primer the 4:1:1:1 turns it into a primer sealer, which is a lot thinner. the 4:1:1:1 turns it into a primer sealer, which is a lot thinner. That’ll be the perfect foundation for you to put your base coat clear coat on top of. why use a sealer over primer? i just finished block sanding the 2k high build primer on my truck at 120 grit. I noticed it was always at the edge of the primer after lots of research i've came to the conclusion that i'm rubbing. base coat is 1:1 base and stabilising thinners. I always got the impression that nothing was considered to be as good as 2k base then 2k clear coat, but the paint on aaron's. Primer is your sealer unless you sanded thru in spots. you should go with epoxy, but if you’re going to be 240 grit, all of your paint, then i would put two medium to heavy coats of 2k filler primer on it and block it down with 400 grit sandpaper. I sanded through to bare metal in a few spots. I don't use sealer but you need to get. some of the cheaper 2k's and most of the old 1k primers are bad about sucking up base paint requiring more coats. the results look very impressive.